U-Line UHRE115 User Manual & Service Manual page 15

USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
Ice
ICE CUBE THICKNESS ADJUSTMENT
NOTICE
Ice thickness adjustment should only be made
one increment at a time. Allow ice maker
production to stabilize for 24 hours before
rechecking ice thickness.
Ice is produced in layers resulting in a clear cube. Ice in
bin may develop surface frost which disappears when cube
is placed in liquid.
Ice cubes in any given batch will vary, so it is necessary
to choose cubes from the sample area for comparison
when making adjustments.
The ice cube thickness is factory set for best overall
performance. The factory setting "0" is designed to
maintain an ice bridge of approximately 1/16" to 1/8"
(1.6 mm to 3.2 mm) under normal conditions, resulting in
a dimple of approximately 1/4" to 1/2" (6.4 mm to
12.7 mm) in depth. A fuller cube with less of a dimple
results in a thicker ice bridge. As the ice bridge thickens,
the tendency for the cubes to stay together as a slab
increases. A bridge thicker than 1/8" (3.2 mm) may cause
cubes to overfill the ice bucket.
32 ice cubes are formed on a 4 x 8 slab during each cycle.
Each cycle takes approximately 15-20 minutes at the
default cube thickness (0).
7/8"
(22 mm)
7/8"
(22 mm)
DIMPLES
ICE BRIDGE
Your clear ice machine is pre-set to produce ice between
the optimal dimensions illustrated below:
1/4" TO 1/2"
(6.4 mm to 12.7 mm)
DIMPLE
Factory Default Setting - 0
THINNER BRIDGE
DEEPER DIMPLE
< 0
SETTING
15
u-line.com
Cube Details
1/16" TO 1/8"
(1.6 mm to 3.2 mm)
ICE BRIDGE
THICKER BRIDGE
SHALLOWER DIMPLE
> 0
SETTING
Ice 1