Table of Contents
Advertisement
Viewing Snapshots and Movies on a TV Screen
1.
Use the AV cable that comes with the camera to connect it to the TV.
White
Yellow
Video
TV
AUDIO IN jack (red)
AUDIO IN jack (white)
VIDEO IN jack (yellow)
• Make sure that you insert the cable connector into the USB/AV port until you
feel it click securely into place. Failure to insert the connector fully can result in
poor communication or malfunction.
• Note that even while the connector is fully inserted, you still
will be able to see the metal part of the connector as shown
in the illustration.
• Before connecting to a TV to display images, be sure to
configure the camera's [r] (REC) and [p] (PLAY)
buttons for "Power On" or "Power On/Off" (page 143).
• Make sure that the camera is turned off before plugging in or unplugging the
cable. Check the user documentation that comes with the TV for information
about requirements before plugging into or unplugging from the TV.
2.
Turn on the TV and select its video input mode.
If the TV has more than one video input, select the one where the camera is
connected.
3.
Press [p] (PLAY) to turn on the camera.
This will cause an image to appear on the TV screen, without anything appearing
on the camera's monitor screen.
• Pressing [ON/OFF] or [r] (REC) will not turn on the camera while the AV
cable is connected.
• You also can change the aspect ratio of the screen and the video output
system (page 144).
4.
Now you can display images and play back movies as you normally do.
AV cable (bundled)
Red
Audio
102
USB/AV port
Making sure that the 6 mark on the
camera is aligned with the 4 mark of
the AV cable connector, connect the
cable to the camera.
Viewing Snapshots and Movies
Advertisement
Table of Contents
