Utilitech CZQTV5MLSCN Manual page 5

INSTALLATION INSTRUCTIONS
SUSPENDED CEILING OPTION:
1. Select a ceiling tile in the desired location and a
mounting installation option (either Swivel or key Slot
installation. See previous page for option descriptions).
(Note: heater should be at least 3 feet (0.9m) away
from the nearest wall or other combustible material)
2. Using the mounting bracket as a template, mark the
tile with the appropriate hole location(s).
3. Construct a Mounting Board. See "Installing a
Mounting Board" on the previous page. Note the
length of the board should be exactly 23.75 inch
(603.25mm) long.
4. Remove the marked tile from the ceiling. Position the
mounting board behind the tile and behind the marked
hole location(s). Make sure the ends of the mounting
board and the tile are aligned.
5. Drill 1/8-inch (3.2mm) hole(s) THROUGH THE TILE
AND MOUNTING BOARD WHERE MARKED.
6. Using the hardware supplied, attach the mounting
bracket to the mounting board with the ceiling tile
sandwiched in between (See Fig. D).
7. Reinstall assembled heater bracket/ceiling tile/
mounting board in ceiling. Refer to "Attaching Heater
to Mounting Bracket" in these instructions.
ATTACHING HEATER TO MOUNTING BRACKET:
Always remove screw from each arm first before attaching heater to mounting bracket. Do not forget to
WARNING:
replace the screws back to each arm after attaching heater, otherwise heater could slide out of mounting bracket and
cause injury or damage.
1. Your heater is equipped with rotating arms at each end of the unit. To conserve space in shipment these arms
are in line with the heater body and must be repositioned before installation. With your heater laying face down,
rotate each arm slowly upward until they are perpendicular to the body. For safety reasons, once rotated, the arms
cannot be returned to their original position.
2. Remove screw from both arms, then holding the heater by the arms (one in each hand) slide the arms onto the
mounting bracket until it locks into place.
3. Replace the screws back to each arm after attaching heater (Do not forget to replace the screws back into each
arm and nut after you finish attaching it to the heater, otherwise would cause heater to slide out of mounting
bracket and cause injury or damage.)
4. Plug the heater into a 120V A.C. grounded outlet. Keep the cord away from the front of the heater. Always plug
heaters directly into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap (outlet/
power strip). Always unplug heater when not in use.
5. Adjust the angle and rotation of the heater to direct the heat where needed.
Do not adjust the heater while it is operating. Do not adjust the halogen lamp while it is operating. The metal
CAUTION:
parts of the housing and the lampshade get very hot and can cause a burn. Always turn your heater off and allow time
for it to cool before adjusting.
REMOVING HEATER FROM MOUNTING BRACKET:
1. Unplug heater and allow to cool.
2. Remove screw from each arm.
3. Push-in the two tabs on the outside of each arm
4. Grasp both arms and simultaneously pull the unit down while holding the tabs in.
Do not attempt to remove the heater one arm at a time as this could cause damage to the heater cabinet.
WARNING:
The rotating arms on this heater will not fold flat with the body of the heater for safety reasons. Attempting to
NOTE:
fold this heater flat could cause damage to the heater housing.
Suspended Ceiling – Figure D
CEILING
TILE
MOUNTING
BRACKET
KEY SLOT
HOLES
5
MOUNTING
BOARD