Setup Menu; Speaker Distance; Dynamic Range Control Setup; Dual Mono Setup - Pioneer SX-316-S Operating Instructions Manual

05 The System Setup menu
4 Adjust the level of each channel using the
(cursor left/right) buttons.
If you selected T. TONE M., use
up/down) to switch speakers.
The T. TONE A. setup will output test tones in
the following order:
L
SW
Adjust the level of each speaker as the test
1
tone is emitted.
5 When you're finished, press RETURN .
Tip
• You can change the channel levels at any
time by using EFFECT/CH SEL and LEVEL
+/– on the remote.

Speaker Distance

1 Select ' SP DISTN. ' from the SP SETUP
menu.
2 Use (cursor up/down) to choose the
speaker that you want then set the distance.
Use (cursor left/right) to adjust the
distance of each speaker (in 10 cm
increments).
3 When you're finished, press RETURN .

Dynamic Range Control Setup

• Default setting: OFF
1 Select DRC from the OTHER setup menu.
2 Use (cursor left/right) to choose the
setting that you want.
• OFF – No dynamic range adjustment (use
when listening at higher volume).
Note
1 • If you are using a Sound Pressure Level (SPL) meter, take the readings from your main listening position and adjust the level
of each speaker to 75 dB SPL (C-weighting/slow reading).
• The subwoofer test tone is output at low volumes. You may need to adjust the level after testing with an actual soundtrack.
24
En
(cursor
C R
RS
LS
• MID – Mid setting.
• MAX – Dynamic range is reduced (loud
sounds are reduced in volume while
quieter sounds are increased).
3 When you're finished, press RETURN .

Dual Mono Setup

Default setting: CH1
•
1 Select DUAL MONO from the OTHER

setup menu.

2 Use (cursor left/right) to choose the
setting that you want.
• CH1 – Only channel 1 is played
• CH2 – Only channel 2 is played
• CH1 CH2 – Both channels are played
through the front speakers
3 When you're finished, press RETURN .

LFE Attenuator Setup

• Default setting: ATT 0 dB
1 Select LFE ATT from the OTHER setup
menu.
2 Use (cursor left/right) to choose the
setting that you want.
• LFEATT 0 – No limiting (recommended
setting)
• LFEATT 10 – 10 dB of limiting
• LFEATT ** – No sound from LFE channel
3 When you're finished, press RETURN .