Setting Up The Universal Remote Control - Philips SRU5110/86 User Manual

2.2 Setting up the universal remote control
This is only necessary if your TV does not respond to the
SRU5110.
If that is the case, the SRU5110 does not recognize the
brand and/or model of your TV and you need to program
the remote control to do so.
1
S witch ON the TV manually or use the original remote
control for this. Tune to channel 1.
2
P ress and hold the
button for 5 seconds until
the green Setup light
lights up.
• T he remote control is
now in setup mode.
3
L ook up the 4-digit code for
your brand in the brand list
at the back of this user
manual.
A four-digit code is shown
for each brand.
U se the digit buttons to
enter the code for your
brand.
• I f the green Setup light
turns off, an invalid
code was entered. In
this case, try again.
4
A im the remote control at
the TV. Press and hold the
button. Release it
immediately as soon as the
TV switches off.
• T his step normally
takes between 5 and 60 seconds. In extreme
circumstances this step can take up to 15 minutes.
5
S witch ON the TV. Try out
the buttons that you need
for operating it. Try, for
example, if the - PROG +
and digit buttons function
properly.
• I f a button does not work as expected, press and hold
that button. Release it immediately as soon as it works.
For more information, see chapter 2.2.1.
EN
4
5 sec.
5-60 SEC.
5 - 60 sec.
6
P ress the button
twice to finish setup.
• W hen no button is
pressed for 5 minutes
or more, the remote
control will exit setup
mode, automatically saving all your settings.
Important
If you made a mistake:
• P ress the button twice to exit setup.
The green Setup light turns off.
• Restart from the beginning.
• If the device does not respond at all or not to all of the
button commands or if you cannot find the code for your
brand, enter '9, 9, 9, 9' in step 3 and continue with step 4.
The remote control will now search its full database for a
code that works with your TV. Full database search may
take up to 15 minutes.
2.2.1 Improving buttons
When correctly set up, the remote control should be able to
operate your TV. However, when using the remote control
for the first time it might occur that some buttons do not yet
function as expected.
In this case you can have the remote control search for
alternatives.
Note
Improving buttons is not possible when the code was
found during full database search (with code '9, 9, 9, 9').
During initial setup
1
M ake sure the TV is switched on.
2
P ress the button that does not function, keep it pressed
and immediately release it when the TV responds.
Repeat this for every button that does not function.
• I f the button still does not function as expected, try
pressing it again for a longer period of time.
2 x
EN
5