Dial Swap Configuration (Af/Rf Gain Controls ) - Yaesu FT DX 9000 Series Operation Manual

D S
IAL
Using the Menu, it is possible to change the RF GAIN control (for the Main (VFO-A) band) to serve as the Sub (VFO-B)
AF GAIN control. In this case, the Menu Item "GENERAL 038 AF/RF DIAL SWAP" will move the Main (VFO-A) RF
GAIN control function to the knob normally utilized for the Sub (VFO-B) receiver's AF GAIN control. In this way, both the
Main and Sub receiver AF GAIN controls will be on the same shaft, as will the two receivers' RF GAIN controls, and this
may be particularly useful during Dual Receive operation.
MAIN (VFO-A)
RF GAIN knob
Dial Swap Setup
1. Press the MNU key to engage the Menu mode; the
Menu list will appear on the TFT.
2. Rotate the Main tuning dial to select Menu item "GEN-
ERAL 038 AF/RF DIAL SWAP."
3. Rotate the CLAR/VFO-B knob (#
lect "SWAP" instead of the factory-default "NOR-
MAL" selection.
4. Press and hold in the MNU key for two seconds to
save the new configuration and exit to normal opera-
tion.
Quick Point
If the Dial Swap function has been engaged, the Main
(VFO-A) AF GAIN RF GAIN control (#
reconfigured so that it now operates as AF GAIN (MAIN)
AF GAIN (SUB); the Sub (VFO-B) band's AF GAIN
RF GAIN control (#
RF GAIN (MAIN) RF GAIN (SUB).
FT 9000D O
DX PERATION
C
WAP ONFIGURATION
SUB (VFO-B)
RF GAIN knob
) so as to se-
) will be
) will now be configured as
M
ANUAL
C
ONVENIENT
(AF/RF GAIN
MAIN (VFO-A)
AF GAIN knob
F
EATURES
)
CONTROLS
SUB (VFO-B)
AF GAIN knob
Main tuning dial knob
CLAR/VFO-B knob
Page 55
MNU key