Installing The Relay Arm; Installing The Rear Shock Absorber Assembly - Yamaha YZ125 2022 Owner's Service Manual

Damage/pitting/scratches  Replace the
bearings and collars as a set.
3. Check:
• Oil seal
Damage/pitting  Replace.
EAM30069

INSTALLING THE RELAY ARM

1. Lubricate:
• Oil seal
• Bearing
• Washer
• Collar
Recommended lubricant
Molybdenum disulfide grease
2. Install:
• Bearing "1"
• Washer "2"
• Oil seal "3"
New
(into the relay arm "4")
• Collar "5"
Installed depth "a"
0 mm (0 in)
a
1
2 4
3
1
3
2
3. Install:
• Bearing "1"
• Oil seal "2"
New
(into the connecting arm "3")
• Collar "4"
REAR SHOCK ABSORBER ASSEMBLY
2
3
1
3
5
2
4-58
Installed depth "a"
0 mm (0 in)
4
2
1
a
a
1
2
EAM30070
INSTALLING THE REAR SHOCK
ABSORBER ASSEMBLY
1. Lubricate:
• Bearing (lower side)
• Dust seal
• Collar
Recommended lubricant
Molybdenum disulfide grease
ECA24580
NOTICE
Do not apply the grease to the bearing outer
race because it will wear the rear shock ab-
sorber surface on which the bearing is press
fitted.
2. Lubricate:
• O-ring
Recommended lubricant
Lithium-soap-based grease
3. Install:
• Bearing
• Stopper ring
New
(into the rear shock absorber assembly (up-
per side))
TIP
• Install the bearing parallel until the stopper ring
groove appears by pressing its outer race.
• After installing the stopper ring, push back the
bearing until it contacts the stopper ring.
4. Install:
• Bearing "1"
• Bushing "2"
• Collar "3"
• Dust seal "4"
New
(into the rear shock absorber assembly (low-
er side))
3