Table of Contents
Advertisement
a
9
b
c
135°
c
:
Apply a mark (c) to the other side of
the locknut (9) halfway between the
other two marks at about 135° (half
of 270°).
:
Rotate the front end of the drive
tube 135° counterclockwise
(arrow) until the marks on the front
end of the drive tube (A) and the
locknut (c) are in alignment.
Do not turn the two parts of the drive
tube any further.
SP 200
135°
A
3
4
Mounting the Gearbox
:
Place the machine on the ground so
that it rests on the engine support.
:
Loosen the clamp screw (1) on the
gearbox (2) – do not unscrew it
completely.
:
Push the gearbox onto the front end
of the drive tube (3) as far as stop –
the necked area (4) of the drive tube
is then covered.
2
1
English / USA
5
5
:
Line up the gearbox so that the
open side of the hook (5) points
vertically downward.
:
Tighten down the clamp screw
firmly.
The two parts of the drive tube and
the gearbox must be in exactly this
position when the drive tube is
separated for transportation of the
machine – see chapter on
"Transporting the Machine".
:
Check swivel range of hook – see
"User Checks and Maintenance".
15
Advertisement
Table of Contents
