Table of Contents
Advertisement
English / USA
6
47 mm
7
:
Screw the nut (6) onto the thread (3)
as far as stop.
:
Hold the front end of the drive tube
(2) steady with the 36 mm open-end
wrench (8) and use the 47 mm
wrench (7) to tighten down the nut
firmly.
14
2
36 mm
8
:
Hold the drive tube at the engine
end steady and rotate the front end
of the drive tube counterclockwise
(arrow) as far as stop.
:
Apply marks (a, A) to the front end
of the drive tube and the thin locknut
(9) as shown in the illustration.
9
a
A
9
b
A
:
Hold the drive tube at the engine
end steady and rotate the front end
of the drive tube clockwise (arrow)
as far as stop – about 270°.
:
Apply another mark (b) to the
locknut (9) opposite the mark (A) on
the front end of the drive tube.
SP 200
Advertisement
Table of Contents
