Advertisement
Step 4
SENSOR INSTALLATION
1. Get closer than 10 meters from TEMPUS-AG-PR and make sure your smartphone's Bluetooth is turned on.
2. Launch MyToroTempus app from your smartphone or tablet.
3. Select the TEMPUS-AG-PR previously installed. (The two devices, smartphone and PR device, must be connected via
Bluetooth)
4. Click on "Add a sensor"
5. Select the type of sensor you want connect to your TEMPUS-AG-PR.
6. Select the sensor you want connect to your TEMPUS-AG-PR.
7. To properly connect the wiring and complete the sensor installation, follow the next steps described in the app.
1 input model : analog 0-5 V Pressure Sensor.
Support capteur de pression
Red wires: 5V power supply
The sensor's wires are directly wired to the products at the factory. Only the sensor can be disconnected thanks to
its waterproof Metripack-150 connector.
Connecteur Metri‐Pack 150
Metripack-150 connector
The sensor used makes it possible to measure the pressure of the irrigation system from 0 to 16 bars. It will be
installed on the system thanks to its G 1/4 EN837 screw thread.
2 2 . . I I
D D E E N N T T I I F F I I C C A A T T I I O O N N D D E E L L
' '
A A N N C C I I E E N N C C A A P P T T E E U U R R D D E E P P R R E E S S S S I I O O N N
Toro TEMPUS-AG-PR
Données
5 V
Fourni uniquem
Filwat Compact
5
Advertisement
