Dell UltraSharp 27 User Manual page 78

A message is displayed while the cable supporting DP alternate mode is connected to
the monitor under the following conditions:
• When Auto Select for USB-C is set to Prompt for Multiple Inputs.
• When the USB-C cable is connected to the monitor.
If the monitor connect with two ports or more, when the Auto of Input Source is
selected, it will turn to the next port with signal.
Select OSD items of On in Standby Mode in Personalize feature, the following
message will appear:
If adjust the Brightness level above the default level over 75%, the following message
will appear:
• When user selects "Yes", the power message is displayed only once.
• When user select 'No', the power warning message will pop-up again.
• The power warning message will appear again only when the user does a Factory
Reset from the OSD menu.
78 | Operating the Monitor
Switch to USB-C Video Input:
Yes
No
Auto USB-C 90W
Changing to this setting ( without
power consumption. Do you want to continue?
Yes
No
Adjusting to this value will increase power consumpiton above the
default level. Do you want to continue?
Yes
No
DP HDMI
Exit
symbol) will increase