Advertisement
3. Adjustment G-CUT OFF, so that Y = 0.235 ± 0.010 nit.
Adjustment of High Light
1. Adjustment Sub Bright, so that Y = 270 nit.
2. Adjustment R-Drive, so that X = 0.265 ± 0.010 nit.
3. Adjustment B-Drive, so that Y = 0.265 ± 0.010 nit.
2.4. Adjustment for CRT CUT OFF
Preparation:
1. Connect the oscilloscope probe to TPL5.
2. Screen VR min.
3. Set the data Sub Bright, Bright.
4. In service Mode at "Bright" dac press [5] in factory mode to enter
vertical line and adjust by Volume Down or Up button.
5. Adjust "Screen VR" until 1-H Line appears. (AKB OFF)
6. Adjust Bright, so the voltage at TPL5 is 130 volt.
7. Press digit key "5" AKB ON and confirm in picture mode.
2.5. Adjustment Procedure
7
Advertisement
