The Ministry In Essentials; Switching On The Device; Notes On Use; Switching Off The Machine - Siemens KG N Series Manual

To loosen the ice cube tray, twist
2.
the ice cube tray slightly or hold it
briefly under running water.
7 Operation in essence
tie
7.1 Switch on device
Connect the appliance electrically.
1.
→ Page 93
Remark:If the device was previously
turned off via the control panel,
press and hold condense. aThe
appliance starts to cool. aA warning
beep sounds
needle, the temperature display (freezer
compartment) and
the freezer compartment is still too warm.
The warning signal with
2.
Switch off.
a
goes out as soon as the set
temperature is reached.
Set the desired temperature.
3.
→ Page 95

7.2 Notes on use

†When you have set up the device
switched on, it takes up to a few
hours before the set temperature is
reached.
Do not put food in the appliance
until the set temperature has been
reached.
†The front sides of the housing
are temporarily heated. This
prevents condensation from
forming in the area of the door
seal.
3 sec-
blink because
†When you close the door, a
under pressure arise. The door will
then only be more difficult to open.
Wait a moment until the negative
pressure is compensated.

7.3 Switching off the machine

Hold down for 3 seconds
▶
Pine tree.
7.4 Set temperature
Set refrigerator compartment temperature
Press the desired temperature.
▶
The recommended temperature in the
refrigerator compartment is 4 °C.
Set freezer temperature
Press the desired temperature.
▶
The recommended temperature in the
freezer compartment is −18 °C.
8 Additional Features

8.1 Super cooling

With Supercooling, the refrigerator compartment
cools as cold as possible.
Switch on Super Cool before loading
large amounts of food.
Remark:If Super Cool is on, there may
be more noise.
Enable super cooling
Press
▶
a
burns.
Remark:After approx. 6 hours, the
device switches to normal
operation.
ServiceNL
†
95