Periodic maintenance and adjustment
1
1 1
1. Wheel axle
5. Remove the wheel. NOTICE: Do
not apply the brake after the
wheel and brake disc have been
7
removed, otherwise the brake
pads will be forced shut.
To install the front wheel
1. Make sure the brake pads have
not been forced shut.
2. Lift up the wheel between the fork
legs.
3. Insert the wheel axle from the right
side.
4. Install the washer and axle nut.
5. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
70 N·m (7.0 kgf·m, 52 lb·ft)
[ECA11073]
Rear wheel
To remove the rear wheel
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
1. Washer
2. Axle nut
2. Place the motorcycle on a suitable
7-27
WARNING
2
2 2
1
1
stand. (See page 7-26.)
EAU25081
EAU84051
EWA10822