Mounting; Mount The Nicl4 Base Onto A Backbox - ASCOM NICL4 Installation Manual

INSTALLATION GUIDE
Corridor Lamp 4
5

Mounting

The base of the NICL4 mounts to backboxes using an array of holes that allow for mounting on various EU
and North American-style backboxes. In areas where no backboxes are available, the base can be mounted
directly onto flat wall surfaces.
Caution: To prevent a fire hazard because of dust buildup inside the NICL4, regular
inspection and/or cleaning of the NICL4 is required.
Caution: Take proper measures to avoid spreading dust and other particles when applying
maintenance to an NICL4 that is mounted inside a clinical area.
5.1

Mount the NICL4 base onto a backbox

1. Place the base over the backbox with the spring type holding clip pointing to the left.
2. For EU-style backboxes, loosen the screws so that approximately 5mm extend from the backbox so
that the heads of the screws can pass through the key-hole slots.
For North American-style backboxes, insert the screws (included) though the backplate and into the 2-
gang backbox.
3. Position the base until its top is level.
4. Tighten the screws until they are snug. Do not overtighten.
5. Pull the cables from the backbox through the base hole.
TD 93352EN / 25 January 2021 / Ver. A
Mounting
5