Nildx Led Lamp Placement - ASCOM NICL4 Installation Manual

Table of Contents

Advertisement

INSTALLATION GUIDE
Corridor Lamp 4
9

NILDx LED Lamp Placement

A corridor lamp supports up to 4 NILD2 or NILD4-RGB LED boards.
NILDx LED boards are not included and must be ordered separately.
Caution: Bright LEDs behind translucent dome cover. High brightness light is produced by
the LED boards that are placed onto the NICL4 circuit board. Do not stare into the light when
the translucent dome cover is removed.
To place the NILDx LED board(s):
1.
Insert the LED boards into the NICL4. The pins on the LED lamp board are not in the centre of the
board, therefore it is important to make sure that the LED lamp board lines up with the guide marks on
the corridor lamp PCB when the pins are inserted.
The LED lamp connection points are labelled LED0, LED1, LED2 and LED3. Any color LED
board (NILD2) or multi color LED board (NILD4-RGB) can be plugged into any of the
connection points in the corridor lamp. The appropriate position of the LED color is
determined during the system setup.
2.
With the three pins inserted and the LED lamp board lined up with the guide marks, press the LED lamp
board flat onto the corridor lamp PCB. Repeat the procedure on the other required LED lamp boards.
Figure 6. Insert LED Boards
TD 93352EN / 25 January 2021 / Ver. A
NILDx LED Lamp Placement
13

Advertisement

Table of Contents
loading

Table of Contents