Table of Contents
Advertisement
Installation and removal
5.4 Installing on the DIN rail
4. With the securing bar pulled, swivel the device to the DIN rail and press it against the
DIN rail until the spring-mounted securing bar locks into place.
5. Tighten the knurled screw to secure the device additionally (torque 0.5 Nm).
6. Connect the device; see section "Connecting (Page 49)".
Uninstalling
1. Turn off the power to the device.
2. Disconnect all connected cables.
3. If necessary, loosen the knurled screw with your hand or a screwdriver.
4. Using a screwdriver, pull down the catch on the rear of the device.
5. Pull lower part of the device away from the DIN rail.
5.4.2
Mounting rotated by 90°with DIN rail mounting adapter
The DIN rail mounting adapter is not included with the product, see Accessories
(Page 23).
Installation
1. Loosen the two M3 screws and remove the cover of the CLP slot
2. Remove the knurled screw
42
.
Operating Instructions, 03/2022, C79000-G8976-C653-01
.
SCALANCE WxM763
Advertisement
Table of Contents
