Philips AVENT SCD525 Manual page 18

ENGLISH
18
answer to your question, contact the Customer Care Centre in your country.
Question
What is ECO mode?
How does this mode
help the environment?
Why don't the
power-on light of the
baby unit and the LINK
light of the parent unit
come on when I press
the on/off buttons of
the units?
Why does the LINK
light on the parent unit
light up red
continuously and why is
the message 'Searching'
shown on the display?
Why does the battery
light on the baby unit
Why does the parent
unit beep?
Answer
The ECO mode has been developed to enable you to reduce your
energy consumption. Monitoring your baby from a small distance
requires less power than monitoring your baby from a large distance.
When you monitor your baby from a small distance, you can activate
the ECO mode. By switching on the ECO mode, your baby monitor
uses less energy and is therefore more enviornment-friendly.
Perhaps the batteries of the parent unit are empty and the parent unit
is not in the plugged-in charger. Insert the small appliance plug into the
charger, put the adapter of the charger in a wall socket and place the
parent unit in the charger. Then press the on/off button to establish
connection with the baby unit.
Perhaps the non-rechargeable batteries of the baby unit are empty and
the baby unit is not connected to the mains. Replace the non-
rechargeable batteries or connect the baby unit to the mains. Then
press the on/off button to establish connection with the parent unit.
reset function to reset the units to their default settings.
The baby unit and the parent unit are out of range of each other. Move
the parent unit closer to the baby unit.
The baby unit may be switched off. Switch on the baby unit.
The ECO mode is switched on, but the operating range is too large.
Move the parent unit closer to the baby unit or switch off the ECO
mode.
The non-rechargeable batteries of the baby unit are running low.
Replace the non-rechargeable batteries or connect the baby unit to
the mains (see chapter 'Preparing for use').
If the parent unit beeps while the LINK light lights up red continuously
and the message 'Searching' is shown on the display, the connection
with the baby unit is lost. Move the parent unit closer to the baby unit.
If the parent unit beeps and the battery symbol on the display is
empty, the rechargeable batteries of the parent unit are running low.
Recharge the batteries.
If you have switched off the volume while the sound alert is on, the
parent unit beeps whenever the fourth sound level light lights up
because the baby unit has picked up a sound.