Installing The Serveraid-Mr10I Controller In A Pci Express Slot - IBM ServeRAID-MR10i User Manual

2-4
Figure 2.1 Installing the ServeRAID-MR10i Controller in a
PCI Express Slot
Bracket Screw
85022-01
Edge of
Motherboard
Step 7. Configure and Install the SAS Devices, the SATA II Devices, or
Both, in the Host Computer Case
Refer to the documentation for the devices for any
preinstallation configuration requirements.
Step 8. Connect the SAS Devices, the SATA II Devices, or Both, to the
Controller
Use SAS cables to connect SAS devices, SATA II devices, or
both to the ServeRAID-MR10i controller. Refer to
"SAS Device Cables"
Section 2.4.1, "Connecting the ServeRAID-MR10i RAID
Controller to Physical Disks," page 2-8
the controller to physical disks and expanders.
The maximum cable length is six meters. You can connect one
device per SAS PHY unless you use an expander.
ServeRAID-MR10i SAS/SATA Controller Hardware Installation
Press Here
for SAS cable information. Refer to
Press Here
Edge of Motherboard
Section 2.4,
for details on connecting