Suzuki GSX-S1000 Installation Instructions Manual page 14

14/17
3. Connect the Grip Hater Lead Wire 1 to the vehicle harness coupler.
4. Pass the lead wires and fix them with the Clamps 6 as shown in the
illustration.
NOTE:
• Fix firmly the clamp d, tying the lead wires into a bundle so that
• Cut off the excess clamps.
GENUINE SUZUKI ACCESSORIES
they should not be twisted or bent.
GSX-S1000/A
1 1
2 2
GSX-S1000F/FA
1. Clamp the left and right grip heater lead wire, grip heater switch lead wire and right
handlebar switch lead wire. Face the locked part of clamp to downward.
2. Clamp the left and right grip heater lead wire, grip heater switch lead wire and right
handlebar switch lead wire. Face the locked part of clamp to inside.
3. Clamp the grip heater lead wire and left handlebar switch lead wire.
Face the locked part of clamp to downward.
Install the headlight assembly so as not to pinch the grip heater lead wire.
4. Clamp the grip heater lead wire and left handlebar switch lead wire.
Face the locked part of clamp to backward.
Set the clamp within 50 mm (2.0 in) from the back end of the left handlebar switch
coupler.
4 4
3 3