Power Supply; Setting The Time; Listening To The Radio - Panasonic RC-7150 Operating Instructions

A
Bottom of the unit
B
(No battery cover is used.
[RC-7200]
C
TIME SET
OFF
While pressing
FWD FAST REV
TIME SET
or
[RC-7150]
TIME SET
While pressing
RC-7150
[RC-7200]
D
RADIO
1
TIME SET
OFF
4
VOLUME
MIN MAX
[RC-7150]
RADIO
1 ALARM
RADIO/BUZZER
RADIO ON OFF SELECTOR
4 VOLUME
MAX
MIN
)
1
6F22/6LR61
(Not included)
006P 9V
1
2
2
HIGH LOW
DOZE
BRIGHTNESS
RC-7200
M H z
1 0 8
z
k H
4
1 0 X 1 0
1 0 0 0
1 7
9 6 1 3 0
9 2 1 0 0
8 8 8 0
F M
6 0
5 3
A M
PM indicator
DISP/CANCEL
ALARM
HOUR MIN
While pressing
or
SLEEP
z
M H
1 0 8
z
k H
4
1 0 X 1 0
0
1 7
9 6
PM indicator
2
BAND
FM ST
3
2
BAND
FM ST
MONO
G
N IN
T U
AM
B A N D
M O NO
ST
FM
3

Power supply

Using AC power supply cord
Dry cell memory back-up battery (not included)
This battery saves the clock and alarm settings if there is a power
interruption.
If the power is interrupted
≥The time display clears until the unit is turned on again.The clock can
gain or lose up to six minutes an hour while the power is interrupted.
≥The radio and radio alarm do not work while the power is interrupted.
The beep alarm continues to function ([RC-7200] only).
Replacing the battery
≥The service life of this battery is approximately 1 year.
≥If, after a power interruption, the display flashes after turning the unit on
again, the battery needs to be replaced.
Note .
≥Align the poles (+and -) properly when inserting the battery.
≥Do not heat or disassemble the batteries. Do not allow them to contact
flame or water.
≥Remove the battery if the unit is not to be used for a long time.
Mishandling of battery can cause electrolyte leakage which can damage
items the fluid contacts and may cause a fire.
If electrolyte leaks from the batteries, consult your dealer.
Wash thoroughly with water if electrolyte comes in contact with any part of
your body.

Setting the time

Reset the clock regularly to maintain accuracy. (Monthly accuracy +/-30 seconds)
PM
[RC-7200]
While pressing and holding [TIME SET, ¢], press [FWD] or [REV] to
set the time.
[FWD]: Increases the time by one-minute units.
[REV]: Decreases the time by one-minute units.
≥Increase the speed by also pressing [FAST].
≥The seconds are reset to zero whenever [FWD] or [REV] is pressed.
∫Time display
AM : PM indicator does not light.
PM : PM indicator lights.
∫To check the second display
Press and hold [DOZE].
The minutes and the seconds will appear.
∫Changing the brightness of the time display
[HIGH] : For a bright display.
PM
[LOW] : For a dim display.
[RC-7150]
While pressing and holding [TIME SET], press [
set the time.
HOUR
[ ]: Increases the time by one-hour units.
AM
[ MIN ]: Increases the time by one-minute units.
MONO
∫Time display
AM : PM indicator does not light.
PM : PM indicator lights.
∫To check the second display
While pressing and holding [DISP/CANCEL, ALARM], press [SLEEP].
The minutes and the seconds will appear.

Listening to the radio

TUNING
∫ To listen to the radio.
Follow steps 1-4.
∫To turn off
[RC-7200] Press [TIME SET, ¢].
[RC-7150] Set [
AM
Note .
These speakers do not have magnetic shielding. Do not place them near
televisions, personal computers or other devices easily influenced by magnetism.
∫To adjust antenna
FM : Extend and change the direction of the FM antenna cord.
AM : Move the unit to face in the direction of best reception.
FM
TUNING
A
C
D
] to [OFF].
SELECTOR
AM
B
] or [ MIN ] to
HOUR