Table of Contents
Advertisement
Operating the built-in
answering device
Operating the answering device
from a remote location
Preparation: Programming the remote operation ID
1. Press
(Function).
2. Press
3. Enter any 4-digit number (remote operation ID) except
or #.
4. Press
(Set).
5. Press
(Stop).
Operation: Listening to a recorded message from a
remote location
Turn the
(Auto answer) light on before you go out.
Remote operations are available only from a touch tone
telephone.
1. Call your unit.
2. Enter the remote operation ID during the greeting
message.
3. Press
or wait 4 seconds.
2
Only the new recorded messages will be played
back.
To listen to all the recorded messages, press
the new messages have been played back.
20
light on
.
Example :
留守電暗証番号?
1 234
Night mode
Turn on the night mode
Press
"
When a call is received during night mode, the unit
will handle the call silently, either by storing the
received fax into memory or by recording the caller's
message.
Night mode allows you to select a block of time
during which the unit will not ring for outside calls
or make sounds when you change the settings.
This feature is useful when you do not want to be
disturbed, for example, while sleeping.
Listening to recorded messages
When new messages are recorded, the following will be
displayed.
Press
messages.
After the messages are played back, the following will be
displayed.
To erase the messages, press
To save the messages, press
Printing received fax documents
When new faxes are received, the
after
4
light will turn on.
To print the faxes, see "Printing a specfic fax stored in
memory" on page 18.
To print the faxes in the SD Memory Card, see page 23.
Turn off the night mode
Press
light on
(Night mode) for about 3 seconds.
"
is displayed and
(Playback /Flash) to listen to recorded
(Night mode) for about 3 seconds.
lights on.
新しい用件が
録音されました
再生した用件を
消去しますか?
(Yes).
(No).
(Call/Fax list)
Advertisement
Table of Contents
