Panasonic ES-LV9U Operating Instructions Manual page 18

2
Press for more than
2 seconds to activate the
sonic vibration cleaning
mode�
• Splashing of foam is suppressed.
• The battery capacity lamps blink
in order.
• After about 20 seconds, it will be automatically
turned off, or you can turn it off by pressing the
power switch.
3
Remove the outer foil
section and clean with
running water�
• See page 19 for removing the
outer foil section.
• Splashing is reduced by rinsing the shaver in sonic
vibration cleaning mode.
• After rinsing with water, shake the shaver up and
down for a few times to remove excess moisture and
then wipe off any drops of water with a dry cloth.
4
Attach the outer foil
section and dry with the
self-cleaning recharger�
1. Insert the shaver into the
self‑cleaning recharger and
plug the adaptor into a
household outlet.
• Check that the charge status
lamp ( ) is glowing.
2. Press twice.
18
3. Remove the adaptor after the selected mode is
5
Lubricate the shaver�
It will keep the movement of the
blades smooth and maintain a
comfort shave.
1. Apply one drop of oil to each of
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately
4. Switch off the shaver, and wipe off any excess oil
1
► Drying the shaver without the self-cleaning recharger
Dry in a shade and apply oil.
1
2
The DRY lamp glows, and the "Dry/Charge"
mode will start after approximately 6 seconds.
• It is possible to change to the "AUTO" mode
even after the "Dry/Charge" mode has started.
Dry Charge
180 min 0 to 60 min
completed.
the system outer foils.
five seconds.
from the system outer foil with a soft cloth.