Table of Contents
Advertisement
3.
Attach camera to AC adapter and TV cable.
4.
Turn on the camera. TV displays "COMTOOL COMMAND MENU"
5.
Select Item 5 by using Zoom key (T/W).
6.
Press shutter to run Strobe calibration.
If TV displays "STROBE CAL COMPLETE" after calibration, camera is successfully calibrated. If TV
7.
displays error code, camera fails
.
3-6 Video Signal / Calibration (NTSC and PAL) Test
Tools:
AC Adapter
SM Card with Calibration Code
Vector Scope
TV cable, NTSC TV set
Procedure:
1.
Install the SM card with calibration code into camera.
2.
Attach camera to TV cable. Attach the other terminal into
the left-hand upper side hole of CH1 of Vector Scope's
back.
3.
Attach cable into the left-hand lower side hole of CH1 of
Vector Scope's back. Attach the other terminal to TV set.
4.
Attach camera to AC adapter.
5.
Power on the camera. TV displays "COMTOOL
COMMAND MENU"
6.
Select Item 6 by using Zoom key.
7.
Press shutter button. Then TV displays color bars.
8.
Press T/W buttons to adjust the position of six points into
the center of frame on Vector Scope.
Press shutter, TV displays "OK" to show camera is
9.
successfully calibrated.
3-7 LCD Calibration Test
Tools:
AC Adapter
SM Card with Calibration Code
Positioning Fixture
Procedure:
1.
Install the SM card with calibration code into camera.
2.
Attach camera to AC adapter and TV cable.
3.
Power on the camera. TV displays "COMTOOL
18% gray wall
90cm
15
Advertisement
Table of Contents
