Table of Contents
Advertisement
Things You Should Know
6-E Troubleshooting
Problem
The unit does not work.
An alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The unit does not ring.
6-F Wall Mounting
This unit can be mounted on the wall.
1
Push the hook and turn it around.
Turn the hook until a click
is heard.
2
Connect the AC adaptor.
Tuck the telephone line cord inside
the wall mounting adaptor, then push it
in the direction of the arrow.
•The word "UP"
should face
upward.
Cause & Remedy
•Check the settings (1-C).
•Charge the battery fully (6-A).
•Clean the charge contacts and charge
again (6-A).
•Install the battery properly (6-B).
•Place the handset on the base unit and
unplug the AC adaptor to reset. Plug in,
and try again.
•Re-install the battery and place the
handset on the base unit. Try again.
•KX-TG2501AL and KX-TG2501NZ are not
designed to be used with rotary (pulse
dialling) services.
•You are too far from the base unit. Move
closer and try again.
•Place the handset on the base unit and try
again.
•Plug in the AC adaptor.
•Raise the base unit antenna.
•Locate the handset and the base unit away
from other electrical appliances (6-C).
•Move closer to the base unit.
•Raise the base unit antenna.
•Press
to select a clearer channel.
(CH)
•The ringer volume is set to OFF. Press
or
while the TALK indicator light is off
Ö
(2-B).
3
Install screws using the
wall template below.
Connect the telephone
line cord.
Mount the unit,
then slide down.
•Raise the antenna.
•Fasten the telephone
line cord to prevent it from
being disconnected.
4
To charge the handset battery:
Fix the charge contacts (#)
and insert the hook to
the handset hole ($).
•The IN USE/CHARGE
indicator lights.
To Power
Outlet
Problem
While storing a phone
number, the unit starts to
ring.
You cannot store a phone
number in memory.
Previously programmed
information is erased.
You cannot redial by
pressing
(REDIAL)
(HANDSET!LOCATOR)
not function.
The RECHARGE indicator
flashes or the unit beeps
intermittently.
You charged the battery
fully, but the RECHARGE
indicator flashes.
The IN USE/CHARGE
Ñ
indicator light does not
go out while charging.
OR
Wall Template
Cause & Remedy
•To answer the call, press
program will be cancelled. Store the
number again.
•You cannot store a number while the unit
is in the talk mode.
•Do not pause for over 60 seconds while
storing.
•If a power failure occurs, programmed
information may be erased. Reprogram if
necessary.
•If the last number dialled was more than
.
32 digits long, the number will not be
redialled correctly.
•The handset is too far from the base unit
does
or is engaged in an outside call.
•Charge the battery fully (6-A).
•Clean the charge contacts and charge
again (6-A).
•Install a new battery (6-B).
•This is normal.
Screws
Hooks
Hook
Hole
2
1
8.3 cm
. The
(TALK)
8.3 cm
For Australia
To Telephone Plug
connected to Socket
OR
For New Zealand
To Single-Line
Telephone Jack
Advertisement
Table of Contents
