Secure The Power Cord On The Power Supply Module - Cisco Firepower 2100 Series Hardware Installation Manual

Hide thumbs Also See for Firepower 2100 Series:

Table of Contents

Secure the Power Cord on the Power Supply Module

Figure 52: Tighten the Terminal Block Captive Screws

Negative (-) lead wire

Step 6

Repeat these steps for the remaining DC input power source wire as applicable.

Step 7

Use a tie wrap to secure the wires to the rack, so that the wires are not pulled from the terminal block.

Step 8

Set the DC disconnect switch in the circuit to ON. In a system with multiple power supplies, connect each power supply

to a separate DC power source. In the event of a power source failure, if the second source is still available, it can maintain

system operation.

Step 9

Verify power supply operation by checking the power supply LED on the front of the chassis. See

page 12

for the LED values.

To secure the power supply module against accidental removal and thus prevent disrupting system performance,

use the tie wrap and clamp provided in the accessories kit that ships with your Firepower 2100.

Safety Warnings

Cisco Firepower 2100 Series Hardware Installation Guide

Take note of the following component replacement safety warnings:

Installation, Maintenance, and Upgrade

Positive (+) lead wire

Front Panel LEDs, on

Table of Contents