Setting The Time Data; Setting The User's Bit - Panasonic AG-DVC80P Operating Instructions Manual

Setting the time data

Setting the user's bit

By setting the user's bit, memos (dates, times)
and other information consisting of up to 8 digits
in hexadecimal notation can be recorded on the
sub-code track. The user's bit settings are
automatically stored in the memory and retained
even after the power has been turned off.
1
Set the camera recorder's POWER switch to
ON.
2
Select USER as the setting for the UB
MODE item on
RECORDING SETUP screen.
OFor details on the menu operations, refer
to page 36.
:
3
Tilt the OPERATION lever in the 4 direction
and move to the UB PRESET item.
:
4
Press ";" of the OPERATION lever, and
move "1" to YES.
:
32
the setting menu
H
H
H
H
H
H
H
H
H
5
The screen shown below appears. Set the
user's bit using the OPERATION lever.
Tilt the OPERATION lever in the 3 or 4
direction, select the user's bit characters,
press ";" of the OPERATION lever, and
move to the next digit.
OThe numbers 0 to 9 and letters A to F can
be used as the user's bit characters.
OWhen the COUNTER RESET button is
pressed on the screen shown below, the
user's bit is reset to zero.
0
6
Upon completion of the user's bit setting,
press the MENU button. The screen shown
below appears. Tilt the OPERATION lever
in the 4 direction, select YES, and press
";" of the OPERATION lever.
7
Press the MENU button twice to release the
menu mode.
.