Installing The Crossover - Orion XTR1002 Owner's Manual

INSTALLING THE CROSSOVER

There is a tweeter level jumper for adjusting the tweeter. Cutting this jumper will
change the output gain of the tweeter. Where the adjustment should be depends on
the location of the tweeter and your preference. Adjustments can be made from 0dB
to -3dB by cutting the "level jumper". Tweeter phase can be changed by reversing
the polarity of the amplifier output wire connections to the crossover. If the tweeter
is within 6" of the woofer center the tweeter should be in phase with the woofer. If
the tweeter is further than 6" from the center of the woofer, both in phase and out
of phase should be tried to see which is best.
Use wire tie or screws to secure crossover housing in place.
To Tweeter
Figure 3
Figura 3
Abbildung 3
-
+
Level jumper
Crossover
Note: The tweeter positive is the wire marked with the stripe.
Note: Le câble positif du haut-parleur d'aigus est rayé.
Nota. El positivo del tweeter es el cable que tiene la franja.
Hinweis: Der positive Hochtönerdraht ist mit dem Streifen markiert.
Nota: il filo positivo del tweeter è contrassegnato da una striscia.
Nota: O cabo positivo do tweeter está marcado com a listra.
6
Note: Jumper is under top cover of crossover housing.
Remarque : Le cavalier se trouve sous le couvercle du boîtier du filtre.
Nota: El puente está debajo de la tapa de arriba del alojamiento del crossover.
Hinweis: Der Jumper befindet sich unter dem Deckel des Crossover-Gehäuses.
Nota: il ponticello si trova sotto il coperchio superiore del supporto del crossover
Nota: O jumper está embaixo da tampa superior da carcaça do crossover.
+
_
Amplifier
© 2008 directed electronics—all rights reserved