Installing The Crossover - Orion HCCA1002 Owner's Manual

InsTallInG THe CRossoVeR

There is a tweeter level jumper for adjusting the tweeter . Cutting this jumper will
change the output gain of the tweeter . Where the adjustment should be depends on
the location of the tweeter and your preference . adjustments can be made from 0db
to -3db by cutting the "level jumper" . Tweeter phase can be changed by reversing
the polarity of the amplifier output wire connections to the crossover . If the tweeter
is within 6" of the woofer center the tweeter should be in phase with the woofer . If
the tweeter is further than 6" from the center of the woofer, both in phase and out
of phase should be tried to see which is best .
Use wire tie or screws to secure crossover housing in place .
Figure 3
Figura 3
Abbildung 3
-
+
Level jumper
Crossover
Note: The tweeter positive is the wire marked with the stripe.
Note: Le câble positif du haut-parleur d'aigus est rayé.
Nota. El positivo del tweeter es el cable que tiene la franja.
Hinweis: Der positive Hochtönerdraht ist mit dem Streifen markiert.
Nota: il filo positivo del tweeter è contrassegnato da una striscia.
Nota: O cabo positivo do tweeter está marcado com a listra.
6
To Tweeter
Note: Jumper is under top cover of crossover housing.
Remarque : Le cavalier se trouve sous le couvercle du boîtier du filtre.
Nota: El puente está debajo de la tapa de arriba del alojamiento del crossover.
Hinweis: Der Jumper befindet sich unter dem Deckel des Crossover-Gehäuses.
Nota: il ponticello si trova sotto il coperchio superiore del supporto del crossover.
Nota: O jumper está embaixo da tampa superior da carcaça do crossover.
+
_
Amplifier
© 2010 directed electronics—all rights reserved