Daily Use - IKEA SKALAN Manual

ENGLISH
Symbol
off position
there is maximum gas sup‐
ply / ignition setting

Daily use

Warning! Refer to Safety
chapters.
Ignition of the burner
Always ignite the burner before
you place the pots or pans.
To ignite the burner:
1. Push the control knob and turn it
anticlockwise to the maximum position
marked with .
2. Keep the control knob pushed for about
5 sec. As a result, thermocouple heats
up, and the safety device switches off. If
you do not push the knob, the gas supply
is interrupted.
3. When you light the flame, you can adjust
it.
If the burner does not ignite, after
a few attempts, check if the crown
and its cap are in correct
positions.
1 Burner cap
Description
1
2
3
4
5
Symbol
there is minimum gas sup‐
ply
to show the position of the
burner
2 Burner crown
3 Injector
4 Thermocouple
5 Ignition candle
Warning! Do not keep the control
knob pressed for more than 15
seconds. If the burner does not
light after 15 seconds, release the
control knob, turn it into the off
position, and wait for at least 1
minute before trying to light the
burner again.
If there is no electricity, you can
ignite the burner without an
electrical device. In this case,
approach the burner with flame,
push the relevant knob and turn it
anticlockwise to the maximum
gas release position.
Warning! Be careful when you
use open fire in the kitchen
environment. The manufacturer
declines any responsibility in case
of misusing the flame.
If the burner accidentally goes
out, turn the control knob to the
off position and wait for at least 1
minute before trying to light it
again.
When you switch on the mains
after installation or a power cut,
the spark generator activates
automatically.
11
Description