Installing Foot Pads - CYBEX FT 360 Owner's And Service Manual

Installing Foot Pads

! WARNING: Use extreme caution when installing foot pads. Failure to do so could
NOTE: A minimum of two people will be required
to remove the FT 360 from the pallet.
1. Remove FT 360 from pallet (see steps 1A - 1C
and Figure 1).
A. Remove the four bolts securing the FT 360
to the pallet. See Figure 1.
B. With one person on each side, carefully lift
FT 360 and remove FT 360 from pallet.
C. Place FT 360 where it will be used.
2. Installing foot pads onto stabilizers (see steps
2A - 2D and Figure 2).
A. Locate four foot pads 2.00 x 5.25 (#87) and two
stabilizers (#89D).
B. Lay one of the stabilizers (#89D) so that the bottom
side is facing up. See Figure 2.
C. Remove the backing from two of the foot pads and
install foot pads 2.00 x 5.25 (#87) as shown in
Figure 2.
D. Repeat steps A - C for other stabilizer.
3. Installing foot pads onto frame (see steps 3A - 3E and Figure 3).
A. Locate four foot pads 3.00 x 5.00 (#88).
B. Carefully tip FT 360 forward (do not exceed 30 degrees) or just enough to install the
foot pads. See Figure 3 on next page.
C. While one person is holding the FT 360 in a tipped position, remove the backing from
two of the foot pads and install foot pads 3.00 x 5.00 (#88) onto frame as shown in
Figure 2 and then carefully lower FT 360.
D. Carefully tip FT 360 backwards (do not exceed 30 degrees) or just so that there is
enough room to install two of the foot pads.
E. Repeat step C.
Assembly
Page 6-4
Cybex FT 360 Functional Trainer Owner's Manual
result in injury.
Figure 1
87
Figure 2
Remove
(4) bolts
securing
FT 360 to
pallet
87
89D