Advertisement
OCR Type A230
16.9.2
Communication Settings
Select [Communication] → [44. Parallel Output].
44.
Parallel Output
441.Handshake
Disp. Img. Change
442.Reset Cond.
443.Setting Template
444.Disp. Img. Change
Select the camera switching method.
− If you will not specify an image, and will switch between camera A and camera B,
select Easy.
− If you will specify an image and a camera, select Detailed.
16.9.3
Using Serial Input to Switch the Display Camera
Use the following commands to switch the display:
C
%I0
: Switch to camera A − Image "Thru"
R
C
%I1
: Switch to camera B − Image "Thru"
R
C
%I2
: Switch to camera A − Image "Mem"
R
C
%I3
: Switch to camera B − Image "Mem"
R
After executing switching, the following commands are returned.
C
%I
: Switching was executed normally
R
C
%Z
: Switching could not be done
R
→ Check the camera switching settings and the capture camera settings.
C
%U
: An invalid command was sent
R
→ An invalid command (e.g. %I4
Yes
Easy Mode
Latch
Details Mode
No
Details Mode
Communications (Serial and Parallel)
16.9 Switching the Display Camera
C
) was sent.
R
16 − 51
Advertisement
