Nostalgia Electrics Vintage CCP-200 Instructions And Recipes Manual page 9

Assembly of Wheels
1. Insert Axle Rod (F) into Base Support (I).
2. Put on #5 Flat Washer. Slide Wheel (G) into Axle Rod (F)
and add a second #5 Flat Washer.
3. Use Wrench (H) to tighten the #6 Nut Cup.
4. Add #5 Flat Washer, second Wheel (G), another #5 Flat Washer, and #6 Nut
Cap to the other side of the Axle Rod (F), following the directions above.
5. Use Wrench (H) to tighten the #6 Nut Cap.
(H)
Wrench
(#5)
Flat
Washer
(#6)
Nut
Cap
Assembly of Main Unit
1. Place Main Unit (A) onto the top of the Storage Compartment (C).
2. Ensure that the two inserting pins at the bottom of the Main
Unit (A) line up correctly so that Main Unit (A) can be locked
under the beam of the Storage Compartment (C).
7
(F)
Axle
Rod
(I)
(G) Base
Wheel Support