Kenwood DPX-5300BT Instruction Manual page 31

Installation/Connection
Basic procedure
1 Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2 Connect the wires properly.
See "Wiring connection" on page 29.
3
Install the unit to your car.
See the following "Installing the unit (in-dash mounting)".
4
Connect the terminal of the car battery.
5 Press B SRC to turn on the power.
6
Reset the unit. (Page 4)
Part list for installation
(A) Trim plate (only for Toyota car) ( ×1 )
(C) Round head screws ( ×6 )
( )
(B) Wiring harness ( ×1 )
(D) Flat head screws ( ×6 )
( )
Installing the unit (in-dash mounting)
Install onto the car brackets using the supplied screws (C) or (D). The screw
holes differ depending on the model of the cars.
Do the required wiring.
(Page 29)
Dashboard of your car
* Only for illustration purpose.
Use only the specified screws. Using wrong screws
might damage the unit.
Car bracket*
27
ENGLISH