Siemens SIMATIC NET SCALANCE W760 Operating Instructions Manual page 30

Description of the device
4.6 Reset button
Functions of the reset button
The reset button has the following functions:
• Restart of the device
To restart the device, press the Reset button briefly.
Note
If you make changes to the configuration and restart immediately afterwards with the
reset button, the changes may be lost. If you restart the device using the WBM (menu
command "System > Restart") or using the CLI (command "restart" in the Privileged
EXEC Modus), the configuration changes are always retained.
• Loading new firmware
If the "Load & Save" menu command of Web Based Management is unsuccessful, the
reset button can be used to load new firmware. This situation can occur if there is a
power outage during the normal firmware update. You will find further information in
the configuration manual in Downloading new firmware using TFTP without WBM and
CLI (Page 50).
• Resetting the device to the factory defaults
The device can be reset to the factory defaults during operation. You will find more
detailed information in the configuration manual in Resetting the device to factory
defaults (Page 49).
30
NOTICE
Previous settings
If you reset, all the changes you have made will be overwritten by factory defaults.
NOTICE
Inadvertent reset
An inadvertent reset can cause disturbances and failures in the configured network
with further consequences.
Operating Instructions, 03/2022, C79000-G8976-C322-13
SCALANCE W760 / W720