Table of Contents
Advertisement
How to Get Started
3.4
GUI Function
This section provides instructions to run the TPS929120EVM using the TPS929120EVM GUI.
3.4.1
Connection Status
Make sure to power up the EVM board and connect it to the PC through USB2ANY tool before opening
the on-line version GUI or desktop version GUI. If the GUI has been opened but the USB2ANY has not
been connected to the PC, make sure the USB2ANY has been connected to the powered-up EVM board
when plug it into the PC. Other operation orders may lead to GUI working abnormally. Once it happens,
please refresh the on-line version GUI or re-run the desktop version GUI.
The GUI supports both hardware setups with CAN board connected or not connected. When CAN board
connected, the CAN checkbox on the "Device Address" widget should be checked. When CAN board is
not connected, left the CAN checkbox unchecked. Before changing hardware setup, remove the
USB2ANY cable plug from PC.
Before using the GUI, make sure the hardware is connected successfully. You can check the connection
status on the home page where there is a green check mark on the left side of the TPS929120-Q1 body,
which means the USB2ANY is connected to the computer successfully. If there is a red X mark, it means
the hardware is not connected, you must reconnect the device.
After hardware is connected, either "Hardware Connected" or "Hardware not Connected" shows on the
bottom left corner of the GUI. The button to connect or disconnect the GUI to hardware is also available
there. You can click the button to connect to hardware if hardware is not connected or to disconnect from
hardware while hardware connected.
10
TPS929120EVM User's Guide
Figure 11. USB2ANY Firmware Loader
Copyright © 2019, Texas Instruments Incorporated
SLVUBM2B – April 2019 – Revised December 2019
Submit Documentation Feedback
www.ti.com
Advertisement
Table of Contents
