Elation FUZE PENDANT COMPACT User Manual page 7

SAFETY GUIDELINES
• DO NOT TOUCH the fixture housing during operation.
• DO NOT shake fixture, and avoid brute force when installing and/or operating fixture.
• DO NOT operate fixture if the power cord is frayed, crimped, damaged and/or if any of the
power cord connectors are damaged or do not fit into the fixture securely with ease.
• NEVER force a power cord connector into the fixture. If the power cord or any of its connec-
tors are damaged, replace it immediately with a new one of the same power rating.
• DO NOT block any air ventilation slots. All fan and air inlets must remain clean and never
blocked. Allow approx. 6" (15cm) between fixture and other devices or a wall for proper cool-
ing.
• TURN OFF the power and allow approximately 15 minutes for the fixture to cool down before
servicing.
• ALWAYS disconnect fixture from power before performing any service and/or cleaning proce-
dure.
• ONLY handle power cord by the plug end. Never pull plug out by tugging the wire portion of
the cord.
• During the initial operation of this fixture, a light smoke or smell may emit from the interior
of the fixture. This is a normal process and is caused by excess paint in the interior of the
casing burning off from the heat associated with the LED and will decrease gradually over
time.
• Consistent operational breaks will ensure fixture will function properly for many years.
• ONLY use the original packaging and materials to transport the fixture for service.
7