Emerson Micro Motion 1600 Installation Manual page 24

Wiring the channels
March 2022
4.3.2 Wire the Ethernet I/O using M12-terminated cables
(optional)
Prerequisites
Obtain one D-coded M12-terminated Ethernet cable.
Procedure
1. Attach the M12-terminated Ethernet cable to the Ethernet I/O connector on the
2. Attach the other cable end using the pinouts described in the following table.
24
1600 transmitter.
Figure 4-11: M12-terminated cables to the Ethernet I/O
Table 4-2: M12 Ethernet I/O pinouts
Pin Wire color
identification
Pin 1 Orange/White
Pin 2 Green/White
Pin 3 Orange
Pin 4 Green
Outputs on RJ45
Pin1
Pin 3
Pin 2
Pin 6
Micro Motion 1600 Ethernet Transmitters
Installation Manual
00825-0100-1600
Signal name
TDP1/RDP2
RDP1/TDP2
TDN1/RDN2
RDN1/RDN2