Emerson Micro Motion 1600 Installation Manual page 18

Wiring the channels
March 2022
4.2.2 Wire the mA Output
Wire the mA Output for nonhazardous installations.
Prerequisites
Meter installation and wiring should be performed only by suitably-trained personnel
using the appropriate government and corporate safety standards.
Procedure
Wire to the appropriate output terminal and pins.
Figure 4-1: Internally-powered mA Output wiring
A
A. mA Output
B. Channel B
C. 820 Ω maximum loop resistance
D. Signal device
Figure 4-2: Externally-powered mA Output wiring
A
A. mA Output
B. Channel B
C. 5–30 VDC (maximum)
D. See
E. Signal device
18
WARNING
B
Note
This resistor is normally built into the signal device (d). This resistor is not used for HART
communications.
B
Figure 4-3
Installation Manual
00825-0100-1600
C
C
D
Micro Motion 1600 Ethernet Transmitters
D
E