Panasonic Aquarea WH-ADC0309J3E5 Planning And Installation Manual page 207

Menus
Menu
5 Installer setup System setup
Optional PCB connectivity
5.1
To connect to the external PCB
required for servicing�
• If the external PCB is connected (optional), the system will have following additional functions:
1
2
3
4
5
6
7
8
Zone & Sensor
5.2
To select the sensors and to
select either 1 zone or 2 zone
system�
Heater capacity
5.3
To reduce the heater power if
unnecessary�*
* Options of kW vary depending
on the model�
Anti freezing
5.4
To activate or deactivate the
water freeze prevention when
the system is OFF
5.5
DHW capacity
To select tank heating capacity
to variable or standard� Variable
capacity heat up tank with
fast mode and keep the tank
temperature with efficient mode.
While standard capacity heat up
tank with rated heating capacity�
24
Aquarea air-to-water heat pumps - Planning and installation manual - 02/2022
For installer
Default Setting
Buffer tank connection and control over its function and temperature�
Control over 2 zones (including the swimming pool and the function to heat water in it)�
Solar function (the solar thermal panels connected to either the DHW (Domestic Hot Water) Tank or the Buffer Tank�
• DHW is not applicable for WH-ADC *models�
External compressor switch�
External error signal�
SG ready control�
Demand control�
Heat-Cool SW
Zone
• After selecting 1 or 2 zone system, proceed
to the selection of room or swimming pool�
• If the swimming pool is selected, the
temperature must be selected for
T temperature between 0°C ~ 10 °C�
Sensor
* For room thermostat, there is a further
selection of external or internal�
3 kW / 6 kW / 9kW
Yes
Variable
Setting Options / Display
No
Appendix
8
207