Ramsey Electronics UAM4 Manual page 13

23. Install 47uF capacitor C5 (marked 476) near the lower right corner of
U1.
24. Install 47uF capacitor C6 (marked 476) near the lower right corner of
U1.
25. Install 47uF capacitor C13 (marked 476) to the left of U1.
26. Install 47uF capacitors C14 (marked 476) to the right of U1.
The rest of the parts are "through-hole" components, which means they will be
placed on the board from the top and soldered on the bottom. Make sure that
the 2 and 3 pin terminal blocks are installed so the holes to insert the wiring
into are positioned toward the outside edge of the board.
27. Install 2 position terminal block J3 with connection points facing the
edge of the board, located on the bottom edge of the board.
28. Install 2 position terminal block J4 with connection points facing the
edge of the board, located on the bottom edge of the board.
29. Install 3 position terminal block J1with connection points facing the
edge of board, located on the bottom edge of the board.
30. 3 position terminal block J2, with connection points facing the edge of
board, located on the bottom edge of the board.
31. Install screw post output terminal J6 located across the top edge of
the board.
32. Install screw post output terminal J7 located across the top edge of
the board.
33. Install screw post output terminal J8 located across the top edge of
the board.
34. Install screw post output terminal J9 located across the top edge of
the board.
35. Install LED D1 located on the right edge of the board. Note that there
is a flat side on the body of the LED and also the lead on that side is
shorter than the other. Make sure you install the LED so it matches the
pattern on the board and the short lead is placed through the hole with a
rectangular silver pad around it.
36. Install 3 pin header H4, located along the right edge of the board.
37. Install 3 pin header H5, located along the right edge of the board.
38. Install 3 pin header H6, located along the right edge of the board.
UAM4• 13