Ford RANGER Owner's Manual page 186

Station Tuning Control
Seek Tuning
Select a waveband and briefly press one
of the seek buttons. The unit will stop at
the first station it finds in the direction you
have chosen.
Manual Tuning
1. Press the MENU button.
2. Select RADIO mode and then manual
tune.
3. Use the left and right arrow buttons to
tune down or up the waveband in small
increments or press and hold to
increment quickly, until you find a
station you want to listen to.
4. Press OK to continue listening to a
station.
Scan Tuning
Scan allows you to listen to a few seconds
of each station detected.
1. Press the MENU button.
2. Select RADIO mode and then scan.
3. Use the seek buttons to scan up or
down the selected waveband.
4. Press OK to continue listening to a
station.
Station Preset Buttons
This feature allows you to store your
favorite stations, they can be recalled by
selecting the appropriate waveband and
pressing one of the preset buttons.
1. Select a waveband.
2. Tune to the station required.
Ranger (TKD, TKE) Vehicles Built From: 01-10-2014, enAUS, Edition date: 10/2014
Audio System
3. Press and hold one of the preset
buttons until you hear a beep. When
the station has been stored, the preset
number along with the station name
or frequency is displayed for
confirmation.
You can repeat this on each waveband and
for each preset button.
Note: When you drive to another part of the
country, stations that broadcast on
alternative frequencies and are stored on
preset buttons, may be updated with the
correct frequency and station name for that
area.
Autostore Control
This will store up to a maximum of the six
strongest signals available, either from the
AM or the FM waveband and overwrite the
previously stored stations. You can also
store stations manually in the same way
as other wavebands.
1. Press and hold the RADIO button.
2. When the search is complete, sound is
restored and the strongest signals are
stored on the autostore presets.
Traffic Information Control
Many stations that broadcast on the FM
waveband have a TP code to signify that
they carry traffic program information.
Turning Traffic Announcements On and
Off
Before you can receive traffic
announcements, you must press either the
TA or TRAFFIC button. A TA display will
appear to show the feature is switched on.
If you are already tuned to a station that
broadcasts traffic information, TP will also
be displayed. Otherwise the unit will search
for a traffic program.
184