Table of Contents
Advertisement
NLService
†When you use the intelligent dosing
activates or deactivates the
system, the setting is saved.
13.4 Save program settings
You can save your individual program
settings as favourites.
Requirements
†A program is set.
→ †Set program", page 33
†The program settings are
amended.
→ †Adjust program settings", page
33
Press for approx. 3 seconds.
▶
Press
to save it
to call up the program.
Remark:To overwrite the saved
program, repeat the steps.
13.5 Filling the drum with
laundry
Remark:To avoid creasing, keep the
maximum load of the
→ †Programs", Page 28 heed.
Required:The laundry is prepared.
→ †Laundry", Page 32
Open the door.
1.
Make sure the drum is empty.
Place the laundry in the drum.
2.
Close the door.
3.
Make sure that no small items of
laundry are caught in the door.
34
13.6 Dosing detergent and care
agent
In programs where intelligent dosing
is not possible or desired, you can
dose the detergent manually.
Tip:In addition to the intelligent
dosing, you can also add other
detergents such as stain remover,
starch or bleach to the manual dosing
compartment. Do not add additional
detergent to the manual dosing
compartment to avoid overdosing or
foaming.
Remark:Follow directions for
detergent and care agent → Page 33
at.
Pull out the detergent drawer.
1.
Fill with detergent.
2.
→
†Detergent drawer", Page 19
If desired, fill with a care product.
3.
Slide the detergent drawer into the
4.
appliance.
13.7 Starting the program
Remark:If you want to change the time
until the program end, first set the
ready in time.
Press.
▶
aThe drum rotates and a
load recognition takes place, which
can take up to 2 minutes, after
which the water flows into the
device.
aThe display shows whether the program
maduur or the ready in time
displayed.
aAfter the program end, it shows
display:end .
Advertisement
Table of Contents
