Install The Unit - NuTone PM300SS Installation Use & Care Instructions

INSTALL THE UNIT

1 . Run house power cable between service panel and unit
location . Stub out a 2-foot length of power cable inside
the cabinet . Attach the power cable to the unit using an
appropriate 7/8" diameter strain relief (not included) .
NOTE: The HCK44 cord connection kit (optional) can
be used instead of the house power cable . Refer to the
instruction packed with the HCK44 cord connection kit .
2 . Insert the unit in the cabinet, until you feel a 'click' from
both sides of the unit, confirming that the Ease of Install
Hooks rest on the top of the cabinet bottom sides , or
cabinet brackets  or  (FIG . 16) . Move the unit from
left to right, from rear to front and up to ensure the Ease
of Install Hooks are retaining the unit inside the cabinet .
NOTE: The unit will be protruding below the cabinetry until
tightened .
NOTE: If, for any reason, the unit has to be removed from the
cabinet, it is possible to disengage the Ease of Install
Hooks . To do so, while holding and pushing on one
side of the unit, lift simultaneously the Ease of Install
hooks levers (1 and 2, grey parts in FIG . 17) in the
other side of the unit until the hooks are retracted .
FIG. 16
2
1
FIG. 17
11