Fig. 8 - DeWalt DW933 Instruction Manual

FIG. 8

clearly with a pencil. Be sure the shoe is extended forward. Next tip the
saw forward until the front end of the shoe sits firmly on the work
surface. Switch the tool on and allow it to attain maximum speed. Grip
the saw firmly and lower the back edge of tool slowly until the blade
reaches its complete depth. Hold the shoe flat against the wood and
begin cutting. Do not remove blade from cut while it is still moving. Blade
must come to a complete stop.
Wood Cutting
Be sure board is firmly positioned. Don't attempt to turn on when blade
is against material to be cut. This could stall the motor. Place front of
shoe on material to be cut and hold jig saw shoe firmly against the
wood while cutting. Don't force the tool; let the blade cut at its own
speed. Whenever possible, clamp or support work close to the line of
cut; when the cut is completed, shut off power, let blade come to a
complete stop and then lay the saw aside before loosening the work.
Use the higher speed setting for cutting wood.
Rip & Circle Cutting
Ripping and circle cutting without a pencil line are easily done with an
accessory Rip Fence and Circle Guide (available at small extra cost).
When using the Rip Fence and Circle Guide, the shoe must be in the
Anti-Splintering position. When ripping: insert rip fence in either side of
saw with cross bar facing down; adjust to width of cut and tighten screw.
When circle cutting: Insert rip fence from either side with cross bar
facing up; adjust rip fence so that distance from blade to hole in cross
bar is the desired radius and tighten screw; place saw so that center of
hole in cross bar is over center of circle to be cut (make pocket cut, drill
hole for blade or cut inward from edge of material to get blade into
position). When saw is properly positioned, drive a small nail through
hole in cross bar into exact center of circle to be cut. Using rip fence as
a pivot arm, begin cutting circle.
Rip Fence & Circle Guide
(AVAILABLE AT EXTRA COST)
Permits ripping without a penciled line and circle cutting with jig saws.
CAUTION: Recommended saw blades and accessories for your
saw are listed in this manual. The use of any other type of blade or
accessory might be hazardous.
Lubrication
It is recommended that, at least once a year, you take or send the tool
to a service center for a thorough cleaning, inspection and lubrication
of the gear case.
Accessories
Recommended accessories for use with your tool are available at extra
cost from your local service center.
CAUTION: The use of any non-recommended accessory may be
hazardous.
A complete listing of service centers is included on the owner's
registration card packed with your tool.
If you need assistance in locating any accessory, please contact
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
E
21286 or call 1-800-4-D WALT (1-800-433-9258).
E
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
8