Table of Contents
Advertisement
User
Understand the aforementioned and do not exceed 120℃ and 500℃ respectively for the
Training
liquid in the general and high-temperature vessels to use the product. In addition, make
sure that the ambient temperature of housing is kept at -20 - +80℃. (However, Ex-Proof
product is limited to a maximum temperature of 350℃ for the liquid in the container.)
Make sure to use high-temperature cables with high-temperature products.(To prevent
damage to the cable). An Ex-proof product is a pressure-resistant and Ex-proof type, so
never open the cover during operation. Ex-proof products are designed according to
Article 34 of the Industrial Safety and Health Act and Article 58.4 of the Enforcement Rules
of the same Act.
Warranty and Service
Warranty
■
This product is subject to the warranty for 2 years of shipment and unpaid service will be
and Contact
provided for any damage found under normal operating conditions. If it is not about the
failure of product, the service charge will be payable.
You can request A/S at our website or by contacting our headquarters.
■ Headquarters ․ Factory ․ Laboratory Contact Number
ADDRESS: HITROL CO., LTD 141, Palhakgol-gil, Jori-eup, Paju-si, Gyeonggi-do, Korea
T E L : 031-950-9700 (Headquarters & A/S)
F A X : 031-943-5600 (Headquarters & A/S)
Ex-proof Version (Certification No.: 09-AV2BO-0097~0099)
Do not apply a Non-ex-proof product in an Ex-proof zone.
An ex-proof product can be used where the environment and liquid inside the
containers are of zone 1 and 2.
* Additional information after product installation
Since this product is set based on specific gravity 0.8 and 1, there is a slight
error depending on the usage environment. If you want to measure in the
correct section, you need to set it on site.
HITROL CO., LTD.
HM-30, 90 Series
17
Advertisement
Table of Contents
