Table of Contents
Advertisement
Marking
■ Product Identification
- The product identification mark is attached onto the housing and shows the model name,
serial number, working temperature, working pressure, and matters regarding output. The
serial number is a unique manufacturing number for the identification of products.
User
The fluid temperature of the container where the product is used shall not exceed 100℃ for HM-10,
120℃ for normal version of HM-12 Series, 250℃ for high temperature version of HM-12 Series, and
Training
200℃ for Ex-proof version of HM-12 Series. In addition, make sure that the ambient temperature of
housing is kept at -20℃ ~ +60℃. In the case of an explosion-proof type product, never open the
cover of the product during use. Ex-proof products are designed according to Article 34 of the
Industrial Safety and Health Act and Article 58.4 of the Enforcement Rules of the same Act.
Warranty and Service
Warranty
■
This product is subject to the warranty for 2 years of shipment and unpaid service will be
and
provided for any damage found under normal operating conditions. If it is not about the
Contact
failure of product, the service charge will be payable.
You can request A/S at our website or by contacting our headquarters.
■ Headquarters ․ Factory ․ Laboratory Contact Number
ADDRESS: HITROL CO., LTD 141, Palhakgol-gil, Jori-eup, Paju-si, Gyeonggi-do, Korea
T E L : 031-950-9700 (Headquarters & A/S)
F A X : 031-943-5600 (Headquarters & A/S)
<HM-10>
<HM-12H>
Do not apply a Non-ex-proof product in an Ex-proof zone. Ex-proof products can
only be installed at zone 1 and 2 of locations where explosive gas atmosphere
exists. It shall be installed in compliance with the ex-proof temperature rating
and the applied fluid temperature.
HITROL CO., LTD.
<HM-12S>
<HM-12H-Ex>
HM-12(10) Series
<HM-12D>
10
Advertisement
Table of Contents
