Door Trim Installation Instructions - Lennox Hearth Products Winslow PS40 Installation And Operation Manual

Door Trim Installation Instructions

Parts List (A):
Qty
(2) Trim Pieces (Gold, Nickel, Brushed Nickel or
Black Nickel )
(6) #10 nuts
(6) #10 washers
Tools Needed:
Qty
(1) 3/8" nut driver or socket wrench
CAUTIoN: Always ensure that plated surfaces are clean
and free of fingerprints before lighting stove. fingerprints
will leave permanent blemishes if left on plated surface
when lit. When installation is complete, the trim should
be gently cleaned with soft cloth and either alcohol or
glass cleaner. Do not overtighten nuts, overtightening
can create visible dimples on the plated surface.
t d t :
o instaLL oor rim
1. Remove the trim pieces and hardware from its packaging
and ensure that all pieces are present before beginning
installation. Take care not to scratch finished surfaces.
2. Open right and left side door. The side doors swivel open
towards the back of the stove. See Figure 24.
3. Open front door. Put trim in place by inserting trim studs
into the corresponding holes in the door (Figures 22 &
25). The top piece of trim will only fit in one direction,
but the bottom piece can be installed incorrectly. When
placing the bottom piece of trim, make sure there is a
9/16" gap between the top of the trim piece and the glass
in the door. (Figure 26)
Pellet Stove Door
figure 
NoTe: DIAGRAMS & ILLUSTRATIoNS ARe NoT To SCALe.
(A)
figure 
figure 
figure 5
Trim Pieces
figure 6
Trim Pieces
Trim Screws
#10 washers
Holes for trim studs
Door Handle
Trim stud
Top of Trim
11