MAINTENANCE AND STORAGE
Regular Maintenance and Lubricate
Check/Tighten fasteners after the first
•
2 hours of use and every 10 hours.
Check and adjust drive chain tension
•
every 20 hours.
Lubricate PTO shaft driveline every 20
•
hours.
Oil drive chain every 10 hours.
•
Check gearbox oil every 20 hours.
•
Check safety shields before each use.
•
Lubricate the bearings #1 & #2(see
•
picture) every 50 hours,
1. Bearing lubricator
2. Bearing lubricator
3. Cap for inlet gearbox oil
4. Cap for gearbox oil level
5. Cap for discharge gearbox oil
STORAGE
At the end of the working season or when the
snow blower will not be used for a long
period, it is a good practice to clean off any
dirt or salt that may have accumulated on the
snow blower and any of the moving parts.
Apply a coat of oil to the chain to prevent rust.
Detach and store the snow blower in
•
an area where children normally do
not play.
Clean as necessary.
•
Check cutting blade for wear and
•
replace if necessary.
Inspect snow blower for loose,
•
damaged or worn parts and adjust or replace as needed.
Do not forget to check the safety labels.
•
Replace worn labels.
•
Store unit inside for longer life.
•
Alternatively, cover with a tarp to reduce exposure and prevent weather damage.
•
Repaint parts where paint is worn or scratched to prevent rust.
•
Storing the snow blower in freezing conditions after use may cause the fan & auger to
•
freeze in place. This may result in breaking PTO shaft shear bolts upon startup.
20