Power Supply Specifications; Dc Power Supply; Input Specifications; Dc Input (Sink/Source) - Mitsubishi Electric MELSEC iQ-F Series User Manual

2.2

Power Supply Specifications

The CPU module power supply specifications are explained below.
For the consumption current of each extension module, refer to Page 26 PRODUCT LIST or manuals of each extension
module.

DC power supply

Item
Power supply voltage
Allowable voltage range
Allowable instantaneous power failure time
Power fuse
Rush current
*1
Power consumption
5 V DC power supply capacity
24 V DC power supply capacity
*1 This item shows value when only the CPU module is used.
The value in [] is the value in the maximum configuration connectable to the CPU module. (The value does not include the external 24
V DC power supply of extension devices)
2.3

Input Specifications

The CPU module input specifications are explained below.
24 V DC input (sink/source)
Input numbers in the table indicate the CPU module umbers.
Item
No. of input points
Connection type
Input type
Input signal voltage
Input signal current
Input impedance
ON input sensitivity current
OFF input sensitivity current
Input response frequency
Pulse waveform
Input response time
(H/W filter delay)
Input response time
(Digital filter setting value)
2 SPECIFICATIONS
Specifications
24 V DC
20.4 to 28.8 V DC
Operation can be continued upon occurrence of instantaneous power failure for 5 ms or less.
125 V, 3.15 A Time-lag fuse
30 A max. 0.5 ms or less/24 V DC
8 W [30 W]
720 mA
500 mA
Specifications
16 points
Connector
FX5UC-32MT/D Sink
FX5UC-32MT/DSS Sink/source
24 V DC +20%, -15%
5.3 mA/24 V DC
4.3 kΩ
3.5 mA or more
1.5 mA or less
X000 to X005 200 kHz
When capturing pulses of a response frequency of 50 to 200 kHz, refer toPage 62 When a
high-speed pulse is captured.
X006 to X017 10 kHz
Waveform
T1 (pulse width)
2.5 µs or more
X000 to X005
50 µs or more
X006 to X017
ON: 2.5 µs or less
X000 to X005
OFF: 2.5 µs or less
ON: 30 µs or less
X006 to X017
OFF: 50 µs or less
None, 10 µs, 50 µs, 0.1 ms, 0.2 ms, 0.4 ms, 0.6 ms, 1 ms, 5 ms, 10 ms (initial value), 20 ms, 70 ms
When using this product in an environment with much noise, set the digital filter.
T1 T1
T2 T2
T2 (rise/fall time)
1.25 µs or less
25 µs or less